Abstract
This paper presents a new in situ Structural Health Monitoring (SHM) system able to identify the location of acoustic emission (AE) sources due to low-velocity impacts and to determine the group velocity in complex composite structures with unknown lay-up and thickness. The proposed algorithm is based on the differences of stress waves measured by six piezoelectric sensors surface bonded. The magnitude of the Continuous Wavelet Transform (CWT) squared modulus was employed for the identification of the time of arrivals (TOA) of the flexural Lamb mode (A0). Then, the coordinates of the impact location and the flexural wave velocity were obtained by solving a set of non-linear equations through a combination of global Line Search and backtracking techniques associated to a local Newton’s iterative method. To validate this algorithm, experimental tests were conducted on two different composite structures, a quasi-isotropic CFRP and a sandwich panel. The results showed that the impact source location and the group speed were predicted with reasonable accuracy (maximum error in estimation of the impact location was approximately 2% for quasi-isotropic CFRP panel and nearly 1% for sandwich plate), requiring little computational time (less than 2 s).