Abstract
Possessing the advantages of both polymeric membranes and the specific inorganic nanoparticles or nanotubes, mixed matrix membranes (MMMs) have captured the imagination of researchers for a possible technological breakthrough for efficient gas separation. However, it is still very challenging to achieve defect-free interface between fillers and polymer matrix. In this study, the naturally abundant and low cost halloysite nanotubes (HNTs) were applied as fillers for MMMs synthesis. To improve the filler dispersion and filler-matrix interface affinity, the raw HNTs were modified by either alkali etching or (3-Aminopropyl) triethoxysilane grafting. After surface etching, the defect holes were formed on the surfaces of etched-HNTs, resulting in the rougher HNT walls and significant increment of surface area and CO2 adsorption capacity. The filler/polymer interfacial voids and filler dispersion were quantitatively assessed by tomographic focused ion beam scanning electron microscopy. HNTs surface etching significantly improved the HNTs/polymer interfacial affinity (void% = 0.06% for Raw-HNTs MMM, 0.02% for Etched HNTs MMMs) and filler dispersion, while grafted-HNTs mainly contribute to the filler dispersion. Compared to the pure polymer membrane and MMMs with untreated HNTs, MMMs containing 10 wt.% etched HNTs filler exhibited both increased CO2 permeability (807.7 Barrer) and higher CO2 selectivity (CO2/CH4 selectivity of 27.8) on the well-known limit of Robeson upper bound. In contrast, grafting HNTs only increased the membrane permeability without enhancing CO2 selectivity. The results suggest that surface etching can be an effective route in filler modification to improve interfacial morphology and membrane separation performance.