Abstract
The conventional surface treatments on stainless steel plates yield slip factors less than the required value for a friction grip, which hinders the application of stainless steel high-strength bolts. The slip factor and the treatment process of stainless steel surfaces are not clearly specified in most of the existing design codes. Existing studies also show different slip factors from similarly treated surfaces. In this paper, a new surface treatment is proposed: the two touching surfaces of the bolted connection are grit-blasted on one side and coated with high-velocity oxygen fuel (HVOF) on the other side. The slip behaviour of the new method was compared with four conventional methods. The roughness and hardness of different surfaces were measured prior to a total of 30 slip tests where the slip factors of multiple stainless steel surfaces were tested. It was shown that the new proposed surface treatment method can yield a slip factor of 0.61, much higher than the conventional surface treatments, meeting the requirements as a slip-resistant connection. The preload relaxation of stainless steel high-strength bolts was also monitored and compared to standard grade 10.9 high-strength bolts. We found that the preload relaxation in stainless steel high-strength bolts is negligible.